Kia Rio: Rear Door / Rear Door Belt Inside Weatherstrip

Repair procedures

Replacement
1.

Remove the rear door trim.

(Refer to Rear Door - "Rear Door Trim")

2.

Remove the rear door belt outside weatherstrip (A) after loosening the mounting screw.

3.

Install in the reverse order of removal.

  

Replace any damaged clips.

    Repair procedures Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch.

    Repair procedures Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 21.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Compressor

    Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of engine. The compressor changes the low pressure and low temperature refrigerant gas into the high pressure and high temperature refrigerant gas.

    Kia Rio 2017-2023 YB Service Manual: Intake Actuator

    Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.011