Kia Rio: Rear Suspension System / Rear Coil Spring

Kia Rio 2017-2023 YB Service Manual / Suspension System / Rear Suspension System / Rear Coil Spring

Repair procedures

Removal
1.

Remove wheel nuts, rear wheel and tire from rear hub.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

  

Be careful not to damage to the wheel nuts when removing the wheel and tire.

2.

Loosen the shock absorber lower bolt.

Tightening torque:

98.0 - 117.6 N·m (10.0 - 12.0 kgf·m, 72.3 - 86.7 lb·ft)

  

Set up the transmission jack under the torsion beam in order to remove the shock absorber in no-load condition.

3.

Remove the rear coil spring.

4.

Install in the reverse order of removal.

    Components and components location Components 1. Shock absorber assembly 2. Dust cover 3. Bumper stopper 4.

    Components and components location Components 1. Torsion beam Repair procedures Removal 1.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Rear Washer Switch

    Repair procedures Inspection Multifunction Switch Inspection [BCM Type] 1. Check for continuity between the terminals in each switch position as shown below. [Left Handle Drive] Switch Switch position Switch terminal

    Kia Rio 2017-2023 YB Service Manual: Power Mosfet (FATC)

    Repair procedures Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0221