| Components |
| [Standard window motor] |

| [Safety window motor] |

| Inspection |
|
Front Power Window Motor
| 1. |
Remove the front door trim. (Refer to Body - "Front Door Trim") |
| 2. |
Remove the front door trim seal. (Refer to Body - "Front Door Window Glass") |
| 3. |
Disconnect the connector (A) from the motor.
|
| 4. |
Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor. [Standard window motor]
[Safety window motor]
|
Rear Power Window Motor
| 1. |
Remove the rear door trim. (Refer to Body - "Rear Door Trim") |
| 2. |
Remove the rear door trim seal. (Refer to Body - "Rear Door Window Glass") |
| 3. |
Disconnect the connector (A) from the motor.
|
| 4. |
Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.
|
Components and components location Component Location 1. Driver power window switch 2. Assist power window switch 3.
Components and components location Components Driver Power Window Switch Connector Pin Information [Front / Rear Driver Safety - Auto Up/Down] [LHD] No.
Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Remove the glass motor (A) after loosening the mounting screws.
Description and operation Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.