| Component |
| Driver Power Window Switch |

| Circuit Diagram |
| [Non-Folding Mirror Type] |

| [Folding Mirror Type] |

| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front left door trim. (Refer to Body - "Front Door Trim") |
| 3. |
Remove the power mirror switch assembly (A) by pulling out both ends of the switch holders (B).
|
| Installation |
| 1. |
Install the power mirror switch. |
| 2. |
Install the front door trim after connecting the connector. |
| 3. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
Remove the front left door trim. (Refer to Body - "Front Door Trim") |
| 2. |
Remove the power mirror switch (A) from the door trim.
|
| 3. |
Check for continuity between the terminals in each switch position according to the table. [Power Mirror Switch]
[Power Folding Mirror Switch]
|
Components and components location Component Location 1. Power door mirror 2. Power door mirror switch 3. Power folding mirror switch
Components and components location Components 1. Side repeater lamp Repair procedures Inspection 1.
Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Remove the glass motor (A) after loosening the mounting screws.
Components and components location Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Cowl top cover 5. Bolt 6. Wiper motor & linkage assembly 7. Wiper motor connector Repair procedures Removal 1.