Kia Rio: Door locks / Operating door locks from inside the vehicle

Kia Rio 2017-2023 YB Owner's Manual / Features of your vehicle / Door locks / Operating door locks from inside the vehicle

With the door lock button

  • To unlock a door, pull the door lock button (1) to the “Unlock” position. The red mark on the button will be visible.
  • To lock a door, push the door lock button (1) to the “Lock” position. If the door is locked properly, the red mark on the door lock button will not show.
  • To open a door, pull the door handle (2) outward.
  • If the inner door handle of the front door is pulled when the door lock button is in the lock position, the button will unlock and the door will open.
  • Front doors cannot be locked if the ignition key is in the ignition switch (or if the smart key is in the vehicle) and any front door is opened.

If a power door lock ever fails to function while you are in the vehicle, try one or more of the following techniques to exit:

  • Operate the door unlock feature repeatedly (both electronic and manual) while simultaneously pulling on the door handle.
  • Operate the other door locks and handles, front and rear.
  • Lower a front window and use the key to unlock the door from outside.

Turn the key toward the rear of the vehicle to lock and toward the front of the vehicle to unlock. If you lock/unlock the door with a key, all vehicle doors will lock/unlock automatically.

■ Driver's door ■ Passenger’s door Operate by pressing the central door lock switch. Press the switch to the “Lock” position (1), all vehicle doors will lock.

Other information:

Kia Rio 2017-2023 YB Service Manual: Smart Key Diagnostic

Repair procedures Inspection Self Diagnosis With Scan Tool It will be able to diagnose defects of SMART KEY system with KDS/GDS quickly. KDS/GDS can operates actuator forcefully, input/output value monitoring and self diagnosis. The following three features will be major problem in SMART KEY system.

Kia Rio 2017-2023 YB Service Manual: Blower Resistor (MANUAL)

Repair procedures Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

Categories

 
Copyright © 2025 www.krioyb.com - 0.0163