Kia Rio: Lubrication System / Oil Level Gauge & Pipe

Kia Rio 2017-2023 YB Service Manual / Engine Mechanical System / Lubrication System / Oil Level Gauge & Pipe

Repair procedures

Removal and Installation
1.

Remove the oil level gauge (A).
2.

Remove the intake manifold.

(Refer to Intake And Exhaust System - "Intake Manifold")

3.

Remove the oil level pipe (A).

Tightening torque:

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

4.

Install in the reverse order of removal.

  

Apply engine oil on the o-ring of the pipe before assembly.

    Components and components location Components 1. Oil screen O-ring 2. Oil screen 3. Oil pan 4. Drain plug gasket 5.

    Repair procedures Removal 1. Drain the engine oil. (Refer to Lubrication System - "Engine Oil") 2.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Smart Key

    Repair procedures Smart Key Smart Key Code Saving 1. Connect the DLC cable of KDS/GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on KDS/GDS. 2. Select the vehicle model and then do "Smart key code saving".

    Kia Rio 2017-2023 YB Service Manual: Intake Actuator

    Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0152