Kia Rio: Hood / Hood Assembly

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly

Components and components location

Component Location

1. Hood assembly

Repair procedures

Replacement

Be careful not to damage the hood and body.

•	When removing and installing the hood, an assistant is needed.

•	When removing the clips, use a clip remover.

Remove the hood assembly (A) after loosening the hood hinge (B) mounting bolts.

Tightening torque :

21.6 - 26.5 N·m (2.2 - 2.7 kgf·m, 15.9 - 19.5 lb·ft)

Install in the reverse order of removal.

•	Make sure the hood locks/unlocks and opens/closes properly.

•	Adjust the hood alignment.

❮Hood

Repair procedures Adjustment 1. After loosening the hinge (A) mounting bolts, adjust the hood (B) by moving it up and down, or right and left.

Hood Insulator Pad❯

Repair procedures Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). Be careful not to damage the hood and body.

Other information:

Kia Rio 2017-2023 YB Service Manual: Immobilizer Control Unit

Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3. Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after

Kia Rio 2017-2023 YB Service Manual: Auto Defogging Sensor (FATC only)