Kia Rio: Front Seat / Front Seat Cushion Cover

Components and components location

Component Location

1. Front seat cushion cover


Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the front seat outer shield cover.

(Refer to Front Seat - "Front Seat Outer Shield Cover")

2.

Remove the front seat inner shield cover.

(Refer to Front Seat - "Front Seat Inner Shield Cover")

3.

Remove the front seat back cover lower protector (A).

4.

Disconnect the heater connector (A).

5.

Pull out the protectors (A), and then front seat cushion cover from the front seat cushion frame.

[lower]

[LH]

[RH]

6.

Remove the front seat cushion cover (A) from the front seat cushion frame.

7.

Remove the front seat cushion cover (C) from the front the seat cushion frame after removing the velcro tape (A) and hog-ring clips (B).

8.

Install in the reverse order of removal.

  

Make sure that the connectors are connected completely

Replace any damaged clips (or pin - type retainers).

To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog - ring clips (A).

Replace the hog-ring clips with new ones using special tool (C) (09880 - 4F000).

    Components and components location Component Location 1. Front seat back cover Repair procedures Replacement    Put on gloves to protect your hands.

    Components and components location Component Location 1. Front seat back frame assembly 2. Front seat cushion frame assembly Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Hazard Lamp Switch

    Repair procedures Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. No. Description No.

    Kia Rio 2017-2023 YB Service Manual: Heater Unit

    Components and components location Component Location Components 1. Heater pipe cover 2. Heater core 3. Mode control actuator 4. Mode control actuator bracket 5. Mode control main lever 6.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0244