| Component Location |

| 1. Front door window glass
|
| Replacement |
Put on gloves to protect your hands. |
|
| 1. |
Remove the front door trim. (Refer to Front Door - "Front Door Trim") |
| 2. |
Remove the door pull handle mounting support (A) after loosening the screws.
|
| 3. |
Disconnect the front door speaker connector (A), and then remove the wiring mounting clips.
|
| 4. |
Remove the front door trim seal (A).
|
| 5. |
Remove the front door belt inside weather strip (A).
|
| 6. |
By operating the power window switch, pull down until the window glass mounting bolt is visible.
|
| 7. |
Loosen the mounting bolt, and pull out the front door window glass (A) by tilting it sideways.
|
| 8. |
Install in the reverse order of removal.
|
Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Repair procedures Inspection 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS). The diagnostic system (KDS/GDS) provides the following information. (1) Self diagnosis : Checking failure and code number (DTC)
Repair procedures Inspection Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. • Before filling the reservoir tank wi