Kia Rio: Front Door / Front Door Latch

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch

Components and components location
Component Location

1. Front door latch


Repair procedures
Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the front door inside handle.

(Refer to Front Door - "Front Door Inside Handle")

2.

Remove the front door window glass.

(Refer to Front Door - "Front Door Window Glass")

3.

Disconnect the front door latch connector (A).

4.

Disconnect the front door latch rod (A).

5.

Remove the front door latch (A) after loosening the mounting screws (B).

Tightening torque :

Screw : 7.8 - 10.8 N·m (0.8 - 1.1 kgf·m, 5.8 - 8.0 lb·ft)

6.

Install in the reverse order of removal.

  

Check that glass operation is normal.

Check the damage glass channel, and replace if necessary.

Adjust glass if necessary.

Front Door Outside Handle
Components and components location Component Location 1. Front door outside handle Repair procedures Replacement ...

Front Door Belt Inside Weatherstrip
Repair procedures Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt ...

Other information:

Kia Rio 2017-2023 YB Service Manual: Manual Transaxle


Components and components location Components 1. Control shaft complete 2. Control cable bracket 3. Transaxle support bracket 4. Roll rod bracket 5. Roll rod support bracket 6. Clutch tube bracket 7. Clutch release cylinder assembly ...

Kia Rio 2017-2023 YB Service Manual: Wheel


Repair procedures Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)    When using an impact g ...

Copyright © www.krioyb.com 2017-2023