Kia Rio: Cruise Control System / Cruise Control Switch

Components and components location

Components

1. Left Remote Control Switch
(Audio + Hands free + Voice)
2. Right Remote Control Switch
(Cruise+Trip Computer)

Schematic diagrams

Circuit Diagram

[Audio]

[Audio + Bluetooth]

[Audio + Bluetooth + Voice]

[Trip]

[Trip + ACC (2 Button)]

[Trip + ACC + SLD (2 Button)]

[Trip + ACC (4 Button)]

[Trip + ACC + SLD (4 Button)]

Repair procedures

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the steering wheel assembly.

(Refer to Steering System - "Steering Wheel")

3.

Remove the steering wheel remote control (A) after loosening the mounting screws.

[LH]

[RH]

4.

Disconnect the steering wheel remote control connector (A).

[LH]

[RH]

Installation
1.

Connect the steering wheel remote control connector.

2.

Install the steering wheel remote control.

3.

Install the steering wheel and driver airbag module.

4.

Connect the negative (-) battery terminal.

Inspection
1.

Check the resistance between terminals in each switch position (LH).

[LH : Audio + Hands free + Voice]

Switch
Connector
terminal
Resistance
(±3%)
SEEK Up
1-6
430 Ω
SEEK Down
1.11 kΩ
MODE
2.11 kΩ
MUTE
3.11 kΩ
Volume (+)
4.61 kΩ
Volume (-)
6.81 kΩ
Voice
10.71 kΩ
END
18.91 kΩ
SEND
40.91 kΩ

2.

Check for resistance between terminals in each switch position (RH).

[RH : Cruise + Trip]

Switch
Connector
terminal
Resistance
(±3%)
Cancel
2-6
390 Ω
SET -
610 Ω
RES +
910 Ω
Cruise ON/OFF
1.38 kΩ
Cruise & Speed Limit ON/OFF
Cruise Mode
2.13 kΩ
Group
1-6
390 Ω
Trip Up
610 Ω
Trip Down
910 Ω
OK / Reset
1.38 kΩ

    Description and operation Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column.

    Specifications Specifications Purge control solenoid valve (PCSV) ▷ Specification Item Specification Coil resistance (Ω) 18.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Receiver-Drier

    Repair procedures Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with L wrench (A). Tightening torque : 2.7~3.2 N.m (0.28~0.

    Kia Rio 2017-2023 YB Service Manual: PTC Heater

    Description and operation Description The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of heater core. The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly effective diesel engine.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0137