Kia Rio: Maintenance / Checking fluid levels
When checking engine oil, engine coolant, brake fluid, and washer fluid, always
be sure to clean the area around any filler plug, drain plug, or dipstick before
checking or draining any lubricant or fluid. This is especially important in dusty
or sandy areas and when the vehicle is used on unpaved roads. Cleaning the plug
and dipstick areas will prevent dirt and grit from entering the engine and other
mechanisms that could be damaged.
Engine oil and filter
The engine oil and filter should be changed at the intervals specified in the
maintenance schedule. If the vehicle is being driven in severe conditions, more
frequent oil an ...
Checking the engine oil level
■ Gamma II 1.6L MPI (Gasoline engine)
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn t ...
Other information:
1. Before closing the hood, check the following:
All filler caps in the engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
engine compartment.
2. Return the support rod to its clip to prevent it from rattling.
3. Lower ...
FCA system is designed to monitor the vehicle ahead through radar signals to
warn the driver that a collision is imminent, and if necessary, apply emergency
braking. In certain situations, the radar sensor may not be able to detect the vehicle
ahead. In these cases, FCA system may not operate. ...