Kia Rio: Blower / Blower Resistor (MANUAL)

Repair procedures

Inspection

1.	Measure the resistance between the terminals.

2.	The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

3.	Installation is the reverse order of removal.

❮Blower Motor

Repair procedures Inspection 1. Connect the battery voltage and check the blower motor rotation. 2.

Power Mosfet (FATC)❯

Repair procedures Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor.

Specifications Specification Item Type Bulb Watt (W) Front Headlamp Halogen Low/High H4 LL 55/60 Turn signal lamp PY21W 21 Position lamp W5W