Kia Rio: Auto Lighting Control System / Auto Light Sensor

Kia Rio 2017-2023 YB Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor

Repair procedures
Inspection

Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor's input (illumination intensity) when the Auto Light Switch in Multi-Function Switch is turned ON, and the vehicle is in IGN1 or IGN2 ON Mode. If IGN1 = ON, BCM detects this voltage, and if the voltage exceeds rated voltage, then auto light failure occurs. (below 4V or above 6V)

  

Failure Occurrence: If auto light failure occurs, the head lamp must be turned ON regardless of sun light level. This is to prevent the head lamp from being turned OFF in case of auto light failure during night time.

In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's input.The auto light control doesn't work if the pin sunlight supply (5V regulated power from Ignition 1 power to sunlight sensor) is in short circuit with the ground.If IGN1 ON, The BCM monitors the range of this supply and raises up a failure as soon as the supply’s voltage is out of range. Then this failure occurs and as long as this is present, the head lamp must be turned on without taking care about the sunlight level provided by the sensor.This is designed to prevent any head lamp cut off when the failure occurs during the night.

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the auto light sensor (A).

3.

Disconnect the auto light sensor connector (B).

Installation
1.

Connect the auto light sensor connector.

2.

Install the auto light sensor.

3.

Connect the negative (-) battery terminal.

Auto Lighting Control System
Specifications Specifications Items Specifications Rated voltage 5V Load Max. 1mA (Relay load) ...

AVN System
Components and components location Component Location 1 . AVN head unit 2. Roof antenna (Radio+GPS+DAB) 3 . Multimedia jack 4 . Steering wheel remote control ...

Other information:

Kia Rio 2017-2023 YB Owners Manual: Transmitter precautions


The transmitter (or smart key) will not work if any of following occurs: The ignition key is in the ignition switch. You exceed the operating distance limit (about 30 m [90 feet]). The battery in the transmitter (or smart key) is weak. Other vehicles or objects may be blocking the signal. ...

Kia Rio 2017-2023 YB Owners Manual: Components of the Tire Mobility Kit


1. Speed restriction label 2. Sealant bottle and label with speed restriction 3. Filling hose from sealant bottle to wheel 4. Connectors and cable for the power outlet direct connection 5. Holder for the sealant bottle 6. Compressor 7. On/off switch 8. Pressure gauge for displaying the tire ...

Copyright © www.krioyb.com 2017-2023