Kia Rio: Light bulbs / Side marker (rear) (Bulb type) bulb replacement (Rear combination lamp Type
A) (for 5 door)

1. Open the liftgate.
2. Remove the service cover.
3. Loosen the light assembly retaining screws with a cross-tip screwdriver.

4. Remove the rear combination lamp assembly from the body of the vehicle.
5. Disconnect the rear combination lamp connector.

6. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
7. Remove the bulb from bulb-socket by pulling it out.
8. Insert a new bulb by inserting it into the bulb-socket.
9. Install the socket in the assembly by aligning the tabs on the socket with
the slots in the assembly. Push the socket into the assembly and turn the socket
clockwise.
10. Connect the rear combination lamp connector.
11. Install the rear combination lamp assembly to the body of the vehicle.
12. Install the service cover.
1. Open the liftgate.
2. Remove the service cover.
3. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assemb ...
If the Side marker (LED) (1) does not operate, have the vehicle checked by an
authorized Kia dealer.
The LED lamps cannot be replaced as a single component because it is part of
an integrated u ...
Other information:
Ignition switch position
LOCK
The steering wheel locks to protect against theft.
The ignition key can be removed only in the LOCK position. When turning the ignition
switch to the LOCK position, push the key inward at the ACC position and turn the
key toward the LOCK position.
The anti-the ...
Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).
3.
Install in the reverse order of removal. ...