Service in
It calculates and displays (in mileage or days) when you need a scheduled maintenance service.
If the remaining mileage or time reaches 1,500 km (900 mi.) or 30 days, a “Service in” message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position.
Service required
If you do not have your vehicle serviced according to the already inputted service interval, a “Service required” message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position.
To reset the service interval to the mileage and days you inputted before:
✽ NOTICE
If any of the following conditions occurs, the mileage and days may be incorrect.
- The battery cable is disconnected.
- The fuse switch is turned off.
- The battery is discharged.
(1) Trip Computer mode This mode displays driving information like the tripmeter, fuel economy, and so on. ❈ For more details, refer to “Trip Computer” in this chapter.
On this mode, you can change setting of the doors, lamps, and so on. WARNING Do not adjust the User Settings while driving. You may lose steering control and/or cause an accident or serious personal injury or death.
Repair procedures Removal Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. Remove the rear combination lamp (A) after loosening the mounting screws. 3.
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circ