Kia Rio: Maintenance / Scheduled maintenance service

Kia Rio 2017-2025 YB Owners Manual / Maintenance / Scheduled maintenance service

Scheduled maintenance service precaution

Follow the Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow the Maintenance Under Severe Usage Conditions.

If your vehicle is operated under the above conditions, you should inspect, replace or refill more frequently than the following Normal Maintenance Schedule. After 120 months or 240,000 km (150,000 miles) continue to follow the prescribed maintenance intervals.

Normal Maintenance Schedule - Non Turbo Models

The following maintenance services must be performed to ensure good emission control and performance.

Keep receipts for all vehicle emission services to protect your warranty. Where both mileage and time are shown, the frequency of service is determined by whichever occurs first.

I : Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change.

Owner maintenance
following lists are vehicle checks and inspections that should be performed by the owner or an authorized Kia dealer at the frequencies indicated to help ensure safe, dependable operation of your ...

Maintenance Under Severe Usage Conditions - Non Turbo Models
The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals. R : Replace I : I ...

Other information:

Kia Rio 2017-2025 YB Service Manual: Vapor Hose and Fuel Filler Cap


Repair procedures Inspection Vapor hose 1. Check all the clamps for tightness and the connections for leakage. 2. Visually check the vapor lines and hoses for cracks, leaks, loose connections, or deformation. Fuel filler cap ...

Kia Rio 2017-2025 YB Owners Manual: Tail lamp (inside) bulb replacement (for 5 door)


1. Open the liftgate. 2. Remove the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from bulb-socket by pulling it out. 5. Insert a new bulb by inserting it in ...

Copyright © www.krioyb.com 2017-2025