
■ Type A

■ Type B
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to operate the rear wiper and washer.
ON - Normal wiper operation
(1) HI - High wiper speed
(2) LO - Low wiper speed
(3) OFF - Wiper is not in operation

■ Type A

■ Type B
Push the lever away from you or turn the wiper lever switch upwards fully to spray rear washer fluid and to run the rear wipers 1~3 cycle. The spray and wiper operation will continue until you release the lever.
■ Type A ■ Type B In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.
Do not use the interior lights for extended periods when the engine is not running as this may cause battery discharge. WARNING - Interior light Do not use the interior lights when driving in the dark.
C
Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper assembly. (Refer to Body - "Rear Bumper Assembly") 3.