| Replacement |
| 1. |
Loosen the rear door checker (B) mounting bolt.
|
| 2. |
Detach the clips, remove the rear door side weatherstrip (A).
|
| 3. |
Install in the reverse order of removal.
|
Repair procedures Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2.
Components and components location Components 1. Rear seat cushion pad 2. Rear seat cushion covering 3. Rear seat back covering 4.
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the vanity lamp (A) using a flat-tip screwdriver. 3. Disconnect the vanity lamp connector (A).
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.