Kia Rio: Front Seat Belt / Height Adjust

Components and components location

Component Location

1. Height adjust


Repair procedures

Replacement
1.

Remove the front seat belt upper anchor.

(Refer to Front Seat Belt - "Front Seat Belt Retractor")

2.

After loosening the mounting bolts, then remove the height adjust (A).

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.9 - 39.8 lb·ft)

3.

Install in the reverse order of removal.

  

Replace any damaged clips.

    Components and components location Component Location 1. Front seat belt retractor Repair procedures Replacement 1.

    Components and components location Component Location 1. Front seat belt buckle Repair procedures Replacement 1.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Cluster Ionizer (FATC only)

    Description and operation Description The cluster ionizer helps to clean up odors in the vehicle or from the air-conditioner system. When the ignition switch ON, the inoizer runs a "CLEAN" mode and then a "ION" mode, switching every about 15 minutes.

    Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0127