Kia Rio: Front Seat Belt / Front Seat Belt Retractor

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Retractor

Components and components location

Component Location

1. Front seat belt retractor

Repair procedures

Replacement
1.

Remove the center pillar upper trim.

(Refer to Interior Trim - "Center Pillar Trim")

2.

Remove the front seat belt upper anchor (A) after loosening the mounting bolt.

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft)

3.

Disconnect the front seat belt retractor connector (A).

Tightening torque :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

4.

Remove the front seat belt retractor (A) after loosening the mounting bolts.
5.

Install in the reverse order of removal.

  
•

Make sure that the connector is plugged in properly.

•

Replace any damaged clips.

    Components and components location Components 1. Front seat belt retractor 2. Height adjuster 3. Rear seat belt retractor [side] 4.

    Components and components location Component Location 1. Height adjust Repair procedures Replacement 1.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Overhead Console Lamp

    Repair procedures Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1.

    Kia Rio 2017-2023 YB Service Manual: Temperature Control Actuator

    Description and operation Description The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.015