Glove box lamp

The glove box lamp comes on when the glove box is opened. To prevent unnecessary charging system drain, close the glove box securely after use.
Vanity mirror lamp

Push the switch to turn the light on or off.
• : The lamp will turn on if
this button is pressed.
• : The lamp will turn off if
this button is pressed.CAUTION
Always have the switch in the off position when the vanity mirror lamp is not in use. If the sunvisor is closed without turning the lamp off, it may discharge the battery or damage the sunvisor.
• 4 Door • 5 Door The trunk/liftgate room lamp comes on when the trunk/liftgate is opened. The trunk/liftgate room lamp comes on as long as the trunk/liftgate lid is open.
CAUTION - Conductors To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window.
Repair procedures Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with L wrench (A). Tightening torque : 2.7~3.2 N.m (0.28~0.
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.