Kia Rio: Drive Belt System / Crankshaft Damper Pulley

Kia Rio 2017-2023 YB Service Manual / Engine Mechanical System / Drive Belt System / Crankshaft Damper Pulley

Repair procedures

Removal and Installation
1.

Remove the engine room front under cover and RH side cover.

(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

2.

Remove the drive belt.

(Refer to Drive Belt System - "Drive Belt")

3.

Remove the crankshaft damper pulley (A).

Tightening torque :

65.7 - 71.6 N·m (6.7 - 7.3 kgf·m, 48.5 - 52.8 lb·ft) + 59 - 61°

  

Use the SST (09231-2B100, 09231-3N100) to remove the crankshaft pulley bolt, after remove the starter.
4.

Install in the reverse order of removal.

  

Turn the crankshaft pulley and align its groove with the timing mark of the timing chain cover to set the piston of No.1 cylinder to the top dead center on compression stroke.
Inspection

Check the crankshaft damper pulley for vibration in rotation, oil or dust deposit of V-ribbed part. Replace if necessary.

    Repair procedures Removal and Installation 1. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Temperature Control Actuator

    Description and operation Description The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.

    Kia Rio 2017-2023 YB Service Manual: Blower Unit

    Components and components location Component Location Components 1. Intake actuator 2. Air filter 3. Air filter cover 4. Resistor 5. Mosfet 6. Intake seal 7. Intake upper cover 8.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0159