Kia Rio: Steering wheel / Horn, Heated steering wheel
Horn
To sound the horn, press the horn symbols on your steering wheel. Check the horn
regularly to be sure it operates properly.
✽ NOTICE
To sound the horn, press the area indicated by the horn symbol on your steering
wheel (see illustration). The horn will operate only when this area is pressed.
Heated steering wheel
With the ignition switch in the ON position, pressing the heated steering wheel
button warms the steering wheel. The indicator on the button will illuminate.
To turn the heated steering wheel off, press the button once again. The indicator
on the button will turn off.
If you turn off the ignition while the steering wheel heater is ON, the heater
will be OFF.
✽ NOTICE
The heated steering wheel will turn off automatically approximately 30 minutes
after the heated steering wheel is turned on.
CAUTION
- Do not install any grip to operate the steering wheel. This causes damage
to the heated steering wheel system.
- When cleaning the heated steering wheel, do not use an organic solvent
such as paint thinner, benzene, alcohol or gasoline. Doing so may damage the
surface of the steering wheel.
- If the surface of the steering wheel is damaged by a sharp object, damage
to the heated steering wheel components could occur.
WARNING
If the steering wheel becomes too warm, turn the system off. The heated steering
wheel may cause burns even at low temperatures, especially if used for long periods
of time.
Tilt steering allows you to adjust the steering wheel before you drive. You can
also raise it to give your legs more room when you exit and enter the vehicle.
The steering wheel should be positione ...
Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is
seen. Make this adjustment before you start driving.
Do not place objects in the rear seat whic ...
Other information:
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp assembly (A) after pressing the locking pin.
3.
Disconnect the license lamp connector (A).
...
Components and components location
Components
[Drum Type]
1. Torsion beam axle
2. Rear spring
3. Rear drum brake disc
[Disc Type]
1. Torsion beam axle
2. Rear spring
3. Rear brake disc
...