Kia Rio: Light bulbs / Headlamp (Low/High beam) (LED type) bulb replacement (Headlamp Type B), Front turn signal lamp bulb replacement (Headlamp Type B)

Kia Rio 2017-2023 YB Owner's Manual / Maintenance / Light bulbs / Headlamp (Low/High beam) (LED type) bulb replacement (Headlamp Type B), Front turn signal lamp bulb replacement (Headlamp Type B)

Headlamp (Low/High beam) (LED type) bulb replacement (Headlamp Type B)

If the headlamp (Low/High beam) (1) does not operate, have the vehicle checked by an authorized Kia dealer.

Front turn signal lamp bulb replacement (Headlamp Type B)

1. Open the hood.

2. Remove the headlamp bulb cover by turning it counterclockwise.

3. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly.

4. Remove the bulb from the bulb socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the bulb-socket. Pull the bulb out of the bulb-socket

5. Insert a new bulb by inserting it into the bulb-socket and rotating it until it locks into place.

6. Install the socket in the headlamp assembly by aligning the tabs on the bulb-socket with the slots in the assembly. Push the bulb-sock et into the headlamp assembly and turn the socket clockwise.

7. Install the headlamp bulb cover by turning it clockwise.

    1. Open the hood. 2. Remove the headlamp bulb cover by turning it counterclockwise. 3. Disconnect the headlamp bulb socket-connector. 4. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly.

    Side marker (front) (LED type) bulb replacement (Headlamp Type B) If the Side marker (LED) (1) does not operate, have the vehicle checked by an authorized Kia dealer.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Rear Glass Defogger

    C

    Kia Rio 2017-2023 YB Service Manual: Rear Washer Switch

    Repair procedures Inspection Multifunction Switch Inspection [BCM Type] 1. Check for continuity between the terminals in each switch position as shown below. [Left Handle Drive] Switch Switch position Switch terminal

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0199