Kia Rio: Lighting / Turn signals and lane change signals
■ Type A
■ Type B
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). The green arrow indicators on the instrument panel indicate which turn signal is operating.
They will self-cancel after a turn is completed. If the indicator continues to flash after a turn, manually return the lever to the OFF position.
To signal a lane change, move the turn signal lever slightly and hold it in position (B). The lever will return to the OFF position when released.
If an indicator stays on and does not flash or if it flashes abnormally, one of the turn signal bulbs may be burned out and will require replacement.
One-touch lane change function
To activate a one-touch lane change function, move the turn signal lever slightly and then release it. The lane change signals will blink 3, 5 or 7 times.
You can choose one-touch lane change blinking function in “One touch turn signal” of “User setting”. Refer to “User setting” in chapter 4. (if equipped)
✽ NOTICE
If an indicator flash is abnormally quick or slow, the bulb may be burned out or have a poor electrical connection in the circuit.
High beam operation
■ Type A
■ Type B
To turn on the high beam headlights, push the lever away from you. Pull it back
for normal (low beam) position. The high beam indicator light will illuminate when
the h ...
Front fog light
Type A
Type B
Fog lights are used to provide improved visibility when visibility is poor due
to fog, rain or snow, etc. The fog lights will turn on when the fog light switch
(1) is turned ...
Other information:
Kia Rio 2017-2024 YB Owners Manual: TPMS (Tire Pressure Monitoring System) malfunction indicator
The low tire pressure telltale will illuminate after it blinks for approximately one minute when there is a problem with the Tire Pressure Monitoring System. If the system is able to correctly detect an underinflation warning at the same time as system failure then it will illuminate both th ...
Kia Rio 2017-2024 YB Service Manual: Vanity Lamp
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the vanity lamp (A) using a flat-tip screwdriver. 3. Disconnect the vanity lamp connector (A). Bulb Replace ...
