Kia Rio: Engine Oil and Filter / Manual Transaxle Oil
Repair procedures
Manual Transaxle Oil
Level Check
1. |
Stop the engine and then raise the vehicle using the lift.
|
2. |
Remove the oil filler plug (A).
[Kappa 1.0
T-GDI, Kappa 1.4 MPI]
[Kappa 1.2
MPI]
[U-2 1.4 TCI]
|
3. |
Check the condition of the oil and make sure that it is at the proper
level (A).
|
4. |
Install the oil filler plug (A).
Tightening torque :
58.9 - 78.5 N·m (6.0 - 8.0 kgf·m, 43.4 - 57.8 lb·ft)
|
[Kappa 1.0
T-GDI, Kappa 1.4 MPI]
[Kappa 1.2
MPI]
[U-2 1.4 TCI]
The existing oil filler plug gasket must be replaced with new
one. (Do not reuse it.)
|
|
Repair procedures
Inspection
Visually check the fuel lines for cracks, leakage, loose connections, deformation
or tank band looseness. ...
Repair procedures
Inspection
[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark p ...
Other information:
Repair procedures
Removal
Rear Combination Lamp
(Outside)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp (A) after loosening the mounting screws.
3.
Remove the rear co ...
Repair procedures
Refrigerant System Service
Basics (R-134a)
Refrigerant Recovery
Use only U.L.-listed service equipment that is certified to meet the requirements
of SAE J2210 when removing HFC-134a (R-134a) from the air conditioning system.
  ...